Disclosure: This post may contain affiliate links, meaning we get a commission if you decide to make a purchase through our links, at no cost to you. Please read our disclosure for more info.
People call a professional plumber once every three years.
You can solve some issues on your own, but how?
When it comes to DIY plumbing, there are steps that you can take to make sure that your pipes stay clean. Here are 5 DIY plumbing tips that you should know. If you don’t want to DIY you plumbing, you can always call a 5-Star Plumbing service.
In This Post:
1. Don’t Over Tighten Fittings
One problem among people who are fixing plumbing issues on their own is that they will tighten the fittings more than they need to be.
They may do this because they don’t want it to leak, but you should make sure that it’s tight enough but that you could still screw it off with your hand.
When you tighten fittings too much, you can also break bolts and screws in the pipes causing further damage.
2. Use Heat to Loosen Pipe Fittings
One of the best DIY plumbing tips may be to use heat to loosen pipe fittings.
If the trap is really tight, it can be difficult to loosen it. You can try using a pipe wrench, but sometimes even that won’t move it. If there is a hardened fitting on the pipe, you may be able to use all of the strength you have and it still may not move.
However, you can use heat to make it a little looser.
To use heat, get a propane torch and apply the heat for a few minutes. After that, try using the wrench again.
However, before you reach for the propane torch, make sure that the pipe you are applying the heat to is a water pipe and not a gas pipe. You also shouldn’t use it on plastic.
3. Use a Wet-Dry Vacuum
Sometimes there can be something clogging up the pipes.
Before you instantly call a plumber, you can try and clear the clog on your own. If it is a hard and small object that may have slipped down the drain, you can always try and use a wet-dry vacuum.
This is an effective way to just suck the object out. Most people decide to try and use a plunger, but this will just push the object farther down the drain and make it more difficult to remove.
4. Don’t Use Drain Cleaners
Another tip is to make sure that you don’t use drain cleaners to remove clogs.
These chemicals can sometimes be too harsh and can actually damage your pipes, which can cost you more money in the long run. Some people also pour in more than the recommended amount, so it’s important to avoid these if you can.
Instead of using these chemicals, try using a snake or a barbed drain cleaner.
5. Use Thread Tape
If you have a pipe that is leaking or has a crack, you can always use thread tape to fix it. Pipes are normally sealed with a thread compound, but it can start to drip.
You can buy multi-purpose tape to fix this, but it may not be thick enough. Depending on what type of pipe it is, you can buy yellow tape for gas or pink for water. This is just a thicker type of tape to make sure that it’s all held together.
When you apply the tape, make sure that it’s applied against the threads. Wrap it counterclockwise around the pipe. You should wrap it three times to make sure that it’s effective.
If the place where you need to apply the tape is in a small, tight space, you can put a few rolls on a cheap pen and apply it with the pen.
Follow These DIY Plumbing Tips
These are some easy DIY plumbing tips that you can use to troubleshoot the problems in your home.
However, if none of these solutions work, you can always call a professional.
If you need help with an issue, call a plumber today!